| BRITEGUARD
CEX |
This highly concentrated liquid
material is used in the final rinse after zinc plate and chromate to enhance the overall
performance of the deposit. It seals and hardens any chromate conversion coating to extend
salt spray protection by as much as 100%. Briteguard CEX will
actually increase chromate adhesion to zinc surfaces. |
|
|
BRITEGUARD
ZD-270 |
This is a
pre-chromate activator used in the rinse station prior to any type of chromate that will
provide a chemically clean, active surface ready to accept the final chromate finish. It
neutralizes electrolyte films from cyanide, alkaline non-cyanide and chloride baths, as
well as remove any organic film that may remain. It will reduce or eliminate chromate
"sloughing" and cracking so often encountered with chloride electrolytes. |
|
|
| BRITEGUARD
RPO |
A water emulsifiable rust
preventative oil designed to provide exceptional corrosion protection on bare steel,
phosphated metal, black oxide, chromate conversion coatings and organic coatings. It
produces a dry to the touch to an oily film, depending upon the finish desired. |
|
|
| BRITEGUARD
AF |
The AF
Series of products are used in chromic acid baths to create and maintain a
foam blanket that prevents chromic acid mist and noxious fumes from entering the
atmosphere. It also lowers the surface tension of the bath, effectively reducing drag-out
of the solution. |
|
|
BRITEGUARD
CB-29 |
This is a unique, chrome free,
highly concentrated material, that is used to apply a thin, invisible, highly protective
film on copper and brass. Unlike lacquers or oils, it reacts with the parts surface to
form a superior corrosion and tarnish barrier. CB-29 is safe and
economical to use, and does not create a waste treatment problem. |
|
|
BRITEGUARD
RP-198 |
A highly
concentrated, water soluble corrosion inhibitor and lubricating finish for bare steel,
zinc plated and phosphated surfaces and most non-ferrous metals. Furnishes the required
torque-tension lubricity for threaded fasteners and, in many cases, can be utilized as a
light drawing or stamping lubricant. |
|
|
| BRITEGUARD
902 |
This product
is designed to apply a thin, dry, corrosion resistant film on any plated surface. It has
been specifically designed to be utilized as a post-dip following any trivalent chrome
plating process. It substantially improves the performance of the plated parts by reducing
the rusting problems so often encountered with trivalent chrome plating. Leaves a dry to
the touch finish that will not interfere with any post-treatment processes. |
|
|
BRITEGUARD
WSLE |
This is a new
and unique water dip lacquer formulation that can be applied over a wide range of metal
surfaces to increase corrosion resistance, eliminate tarnishing, finger marking and
spotting out tendencies. Easy and economical to use, there are several formulations to
meet specific requirements. |
|
|
| A Brite offers a complete line of high technology products for your metal finishing and
environmental needs. For more information on our product line, specific products
(including those discussed above) or to discuss your special requirements, please contact
our technical staff at 214/291-0400 or Toll Free 1-888-8A BRITE |
|
